Adding states and functions

This section contains the procedures for adding a state and a function to the contact rule base; however, the procedure is the same for adding states or functions to any rule base.

To add a state:

1	Click the Common Configuration button on the navigation pane.

2	Double-click Edit Contact Rules.

3	Right-click States and select New State.

4	Type the name of the state in the State Name field.

5	To add a note about the state, type comments in the Notes field.

6	To make this state the initial state, select the Initial State check box. You must have one state (and only one) designated as the initial state before you can compile the rule base.

7	Click the Save button to save the state.

8	To add more states, repeat steps 3 through 7.

To add a function:

1	Double-click Edit Contact Rules on the navigation pane.

2	Right-click Functions and select New Function.

3	Type the name of the function in the Function Name field.

4	To add a note about the function, type comments in the Notes field.

5	Click the Save button to save the function.

6	To add more functions, repeat steps 2 through 5.

Copyright © 2000, , Oracle Corporation and/or its affiliates. All rights reserved. Oracle is a registered trademark of Oracle Corporation and/or its affiliates. Other names may be trademarks of their respective owners.